Manoi PF01

[Chrisbie offline]

Hi guys, I will be receiving my MANOI PF01 soon, not fully assembled.. Hope there are still active MANOI users here... Im very excited... hope you guys can help me out assembling my MANOI... Thanks.... Will keep in touch...

[rep001 offline]

After some well executed negotiations , I am now the proud owner of a Manoi PF01 . It came as described partially built but is currently being completely dismantled. Lots of screws in the wrong places etc ao it will take a while . Pics to follow . I'm hoping he will be fit for the soccer event later this year !
Thanks to Chrisbie for such a speedy delivery .

[Orac offline]

Wow, can't wait to see it in action.

[rep001 offline]

I have just found that servo outputs 6 and 7 on the RCB are dead !
Not sure what to do from here.......

[Orac offline]

I would check for trace damage on the board if you have access to a meter to track back to the IC.

Does the PF01 have spare unused ports like the Manoi? If so, you can assign them to the servos and pair them with the failed channels in HTH.

Orac

[rep001 offline]

Orac,
thanks for that. I had wondered if that was possible , is it covered in the manuals anywhere as i have no clue how you pair using H2H. Does that also mean that none of the stock moves will work from here on with pairing in place.I would try and buy a new board but cannot find anywhere listing/selling one.

[Orac offline]

To be honest, I am not 100% and would need to look through the manual, but if they were linked, the stock moves should work.

I think its in the ICS settings.

[rep001 offline]

Orac

Im still searching but cannot find a reference to pairing , wondered if you had any joy referencing at your end. Looks like a new board me thinks
Almost back after rebuild , will post some pics.

[rep001 offline]

http://robosavvy.com/Builders/rep001/Ma ... %20584.jpg

[Orac offline]

Hi,

Had a quick look, couldn't find anything.

I was sure there was something in the mixing somewhere.

If not, I had a look in the RCB files for the moves and maybe you could run some kind of mass edit script to move the data from the old channel to the new channel. It seems to be a fairly simple file, just need to re-order the 5 figure decimal numbers. The are in sequence for the channels.

Just tried editing manually and it seems to work.

Or you could just buy another board

[rep001 offline]

Robosavvy team to the rescue. They have special ordered a new RCB3 for me and whilst i was at it i asked for an REV-1 module so i can use a p/s control.
He is all packed away until parcel arrives, keep you posted........


thanks