by LISV_ROBOARD » Thu Dec 13, 2012 8:25 pm
by LISV_ROBOARD
Thu Dec 13, 2012 8:25 pm
Hi all,
I am using a Roboard RB-100 to control 2 DC motors. To read the quadrature encoder value, I'd like to use the interrupter function. Can you please let me know how can I do that? I have tried using polling with delay of 50-100 micro Sec, on GPIO ports and the results are not accurate at all.
Thank you in advance,
Hi all,
I am using a Roboard RB-100 to control 2 DC motors. To read the quadrature encoder value, I'd like to use the interrupter function. Can you please let me know how can I do that? I have tried using polling with delay of 50-100 micro Sec, on GPIO ports and the results are not accurate at all.
Thank you in advance,