How to establish basic A/D connection?

Based on DMP's Vortex processor / SoC this board is a full computer capable of running a standard Windows and Linux installation on the backpack of your robot.
1 post • Page 1 of 1
Post a reply
Post a reply
1 post • Page 1 of 1

How to establish basic A/D connection?

Post by scottlobdell » Thu Jan 10, 2013 5:48 pm

Post by scottlobdell
Thu Jan 10, 2013 5:48 pm

I feel like I'm asking a stupid question here, but I could not find any resources online. How do I connect A/D devices to the roboard? Every A/D device I acquired has 3 conductors (+5V, ground, and signal if I understand correctly), and the roboard A/D channels are 2 pins each.

How am I supposed to connect these devices?
I feel like I'm asking a stupid question here, but I could not find any resources online. How do I connect A/D devices to the roboard? Every A/D device I acquired has 3 conductors (+5V, ground, and signal if I understand correctly), and the roboard A/D channels are 2 pins each.

How am I supposed to connect these devices?
scottlobdell offline
Newbie
Newbie
Posts: 1
Joined: Thu Jan 10, 2013 5:43 pm
Top
1 post • Page 1 of 1
Post a reply
Post a reply
1 post • Page 1 of 1
Return to Roboard - x86 Embedded Robot Board

Powered by phpBB® Forum Software © phpBB Group
cron