by plingboot » Wed Dec 19, 2007 3:24 pm
by plingboot
Wed Dec 19, 2007 3:24 pm
hi all,
i'm having problems (no luck) connecting to my RB1000. I don't have a 9pin serial port, but do have 3 different serial/usb convertors (lindy, keyspan and a maplin own brand) i've tried all three and just get errors (checked that im using the correct port).
the error is either a problem with the connection or the board firmware is not compatible with the software - which i find hard to believe.
i did use the lindy convertor with my RN1 and it worked ok.
if anyone has any ideas - i'd much appreciate it - as i'm stuck with just the auto demo at the moment
hi all,
i'm having problems (no luck) connecting to my RB1000. I don't have a 9pin serial port, but do have 3 different serial/usb convertors (lindy, keyspan and a maplin own brand) i've tried all three and just get errors (checked that im using the correct port).
the error is either a problem with the connection or the board firmware is not compatible with the software - which i find hard to believe.
i did use the lindy convertor with my RN1 and it worked ok.
if anyone has any ideas - i'd much appreciate it - as i'm stuck with just the auto demo at the moment