RoboSavvy Forum

Need two etx port

2010-10-26T20:43:49+01:00

I have one more problem, when I run vrbot GUI and creates source code for robobasic I get lots endif, which can not be run.
It is also something wrong with vrgroup when I load from robobasic but not when I download the same file from vrbot GUI.

I've tried to run the mp3card at 4800 baud with the command line print .. it works .. Thanks

Statistics: Posted by Robomate — Tue Oct 26, 2010 8:43 pm

Need two etx port

2010-10-26T20:02:18+01:00

I have a quadravox QV606 MP3 sound card and voice
recognition card so I have to have two tx ports.
I can run the mp3 soundcard at 2400 4800 9600 19200 baud.

Statistics: Posted by Robomate — Tue Oct 26, 2010 8:02 pm

Need two etx port

2010-10-26T16:24:58+01:00

The LCD port always works at 4800 bps, unless you download a firmware patched version for 9600 bps.

The LCD port uses the PRINT command and only takes a number or constant as the value.
So the equivalent for the LCD port would be:
PRINT 10

You don't need any of the other LCD commands.

The only way to send variables to LCD is to use PRINT FORMAT, which sends variables as ASCII encoded values not raw values. This is either really useful or really bad depending on what you want to connect.

What are you trying to connect to the serial ports ? Can you use 4800 bps ?

Statistics: Posted by i-Bot — Tue Oct 26, 2010 4:24 pm

Need two etx port

2010-10-26T11:59:54+01:00

Thanks i-Bot for your prompt response. Can you give me a hint how to write in robobasic, I have tried but, I'm a bit of a newbie, I may have written a bit wrong ..

dim sy as byte
sy = 10
etx 9600, sy

This is the original code in robobasic.
Many thanks in advance.

Statistics: Posted by Robomate — Tue Oct 26, 2010 11:59 am

Need two etx port

2010-10-25T22:27:14+01:00

Within limits, you can use the LCD port as a second serial TX.

Statistics: Posted by i-Bot — Mon Oct 25, 2010 10:27 pm

Need two etx port

2010-10-25T20:50:17+01:00

Hello to all robofans. I have two cards that need tx ports from robonova. Can you convert or is there some other way to get two tx ports.
Please help me.

Statistics: Posted by Robomate — Mon Oct 25, 2010 8:50 pm