RoboSavvy Forum

my robobuilder red led (error) keep on blingking

2009-10-01T18:58:32+01:00

Hi,

have you made any progress ?

I've seen similar problem when I had a firmware problem and it wasn't picking up the type of robot configuration. Have you checked that your serial number reads correctly and tried setting the config type by pressing PF1 at boot.

cheers

Statistics: Posted by l3v3rz — Thu Oct 01, 2009 6:58 pm

my robobuilder red led (error) keep on blingking

2009-09-24T00:02:38+01:00

You could contact the place where you purchased it or contact Robobuilder via phone or leave a message on their forums.

I hope you get some resolution.

Statistics: Posted by Ketchup — Thu Sep 24, 2009 12:02 am

my robobuilder red led (error) keep on blingking

2009-09-19T18:08:12+01:00

hello ketchup,
i try everything u say check all connections, all servos work if u use the
wck programmer but still red led blinking , i even change battery but no luck , anybody has other solution
thanks in advance

Statistics: Posted by chapin — Sat Sep 19, 2009 6:08 pm

my robobuilder red led (error) keep on blingking

2009-09-12T06:36:17+01:00

Start the "Robobuilder Diagnostic tool". Connect the Robobuilder and see what it says. I had a red flashing light and found that one of the servo leads was disconnected.

Hope this helps!

Statistics: Posted by Ketchup — Sat Sep 12, 2009 6:36 am

my robobuilder red led (error) keep on blingking

2009-09-11T03:34:40+01:00

hello everyone
this is my first post i hope someone can help me
here is my problem so far my robot was working perfect but now i keep gettting the red led (error) all the time i try to charge the battery but either won't charge or i'm doing something wrong i check the charger and is fine u think the battery is no good or maybe is got to do with something else
hope someone can help me
thanks in avance

Statistics: Posted by chapin — Fri Sep 11, 2009 3:34 am