RoboSavvy Forum

Robot seems to be stuck after uploading C firmware, anyone?

2010-06-18T02:14:56+01:00

l3v3rz wrote:
Have a look at the IR code - I think each remote control has a code that has to match your IR remote. This is so two remotes won't clash on the same robot. I have disabled this test in the code I use.
cheers

Thank you mate! Appreciate it!

Statistics: Posted by yoshi_sx — Fri Jun 18, 2010 2:14 am

Robot seems to be stuck after uploading C firmware, anyone?

2010-06-17T18:09:48+01:00

Have a look at the IR code - I think each remote control has a code that has to match your IR remote. This is so two remotes won't clash on the same robot. I have disabled this test in the code I use.
cheers

Statistics: Posted by l3v3rz — Thu Jun 17, 2010 6:09 pm

Robot seems to be stuck after uploading C firmware, anyone?

2010-06-17T04:01:00+01:00

l3v3rz wrote:
Do you mean its stuck after reloading original firmware ? Or your firmware has a problem ?

If its oringinal firmware - whats the status of LEDs s? Could it be you need to recharge the battery ?

it's "stuck" after uploading the C firmware.

It does not seem to be responding to my remote control via IR, however, I am able to control it via HyperTerminal? Surprising huh?

I suppose I should look into the IR part of the code eh?

Statistics: Posted by yoshi_sx — Thu Jun 17, 2010 4:01 am

Robot seems to be stuck after uploading C firmware, anyone?

2010-06-16T12:46:39+01:00

Do you mean its stuck after reloading original firmware ? Or your firmware has a problem ?

If its oringinal firmware - whats the status of LEDs s? Could it be you need to recharge the battery ?

Statistics: Posted by l3v3rz — Wed Jun 16, 2010 12:46 pm

Robot seems to be stuck after uploading C firmware, anyone?

2010-06-16T01:44:50+01:00

Hi everyone,

I have recently tried to implement new features in my robot, by programming in C, compiling it into a hex file and uploading it into my robot.

However, once the robot has gone into basic pose, it seems to be stuck, with a "stucked" sound.

Anyone has any idea on what might be the cause? Incorrect initialisation of hardware/software?

Looping errors?

I would greatly appreciate it, if you guys would give me some pointers!

Statistics: Posted by yoshi_sx — Wed Jun 16, 2010 1:44 am