RoboSavvy Forum

Error light when trying to run any custom motions.

2012-01-14T13:52:51+01:00

That makes sense - the motions builder versions needs to link up with the firmware versions - although I'd expect if you use latest version of both there not be a problem. Might be if you have some loaded from one version and some from another there's a problem. Or a bad download has corrupted something. May be you try to clear out the motions and reload ?

Statistics: Posted by l3v3rz — Sat Jan 14, 2012 1:52 pm

Error light when trying to run any custom motions.

2012-01-11T05:25:03+01:00

Nope not fixed it yet, however all the servos are connected as the preset motions work fine and user created ones do to.

I actually think its to do with the verson of motionbuilder i have as everytime i complete the motion and save it then close motionbuilder it says that the project has not been saved.

i had 1.19 beta of motionbuilder so im gonna download the original one again because that worked before.

Statistics: Posted by geothelegend — Wed Jan 11, 2012 5:25 am

Error light when trying to run any custom motions.

2012-01-10T17:55:31+01:00

Did you sort this ? An error led can mean its failing self test due to a servo not being connected

Statistics: Posted by l3v3rz — Tue Jan 10, 2012 5:55 pm

Error light when trying to run any custom motions.

2012-01-04T19:34:25+01:00

So for some reason now when i make a motion and put it on the robot it just gets an error light when i try to run it.

Its not done this before and iv not changed anything since a custom motion last worked.

someone help please ?? O.o

Statistics: Posted by geothelegend — Wed Jan 04, 2012 7:34 pm