RoboSavvy Forum

Robot actions jammed.

2012-02-03T16:55:01+01:00

Hi Phoenix 143

I think it's important to separate 2 things:

1) The internal memory of the processor. This is where the AVR Code is stored.

2) Additionally there is an EEPROM module inside that can be addressed by the processor. However code can't be loaded into the EEPROM (but I guess you alreayd know this).

If your code is too big you may be able to store static info such as Motion Data on the EEPROM though and then read it back during the execution of the program.

You haven't shared much details about your code (ie are you suing the Robobuilder C code, your own custom one, ...) but there may also be some bug in code that's causing execution to halt.

Pedro.

Statistics: Posted by PedroR — Fri Feb 03, 2012 4:55 pm

Robot actions jammed.

2012-01-29T14:35:08+01:00

hiall,
yes i have already tried changing all the cables but it still cant work??
would there be any chance that the RAM has not enough memory?

thanks.

with regards,
kai

Statistics: Posted by pheonix143 — Sun Jan 29, 2012 2:35 pm

Robot actions jammed.

2012-01-28T05:43:57+01:00

have you try to check the servo cable connection?

Statistics: Posted by wiweet — Sat Jan 28, 2012 5:43 am

Robot actions jammed.

2012-01-27T02:37:17+01:00

hi all,

i am experiencing a very weird problem. why is it that my robot will sometimes execute the full program and sometimes jam and stop at the very first motion during a dance that i have created.

there were no errors indicated in the AVR studio when i was compiling. the motors are all doing fine and have no problems. if i run the actions using motion builder the actions can run smoothly but everytime if i load the firmware in this problem of jamming occurs.

thanks. do assist me! this is kind of urgent!

with regards,
kai

Statistics: Posted by pheonix143 — Fri Jan 27, 2012 2:37 am