RoBoard and Matlab questions

2010-03-25T05:27:07+01:00

The RoBoIO library that the Roboard uses is based on C. You'll have to write some routines in C to get the data, then you can call the C code from Matlab.

http://www.mathworks.com/support/compil ... rom_MATLAB

You could also do the reverse, and call Matlab routines from C code but it sounds like you want to do the bulk of your coding from within Matlab.

I haven't used Matlab since college, and didn't do any interfacing with C, so sorry but I can't be of much more help on that side.

Statistics: Posted by veltrop — Thu Mar 25, 2010 5:27 am

RoBoard and Matlab questions

2010-03-24T22:42:27+01:00

Hello all,

I am currently working on a project using sensor fusion of acoustic, infrared, FMCW radar sensors to perform indoor mapping. I would like to use Matlab installed on WinXP OS on the Roboard platform to implement this project.

I would greatly appreciate it if those with experience working on the RoBoard platform could point me to any tips, examples, tutorials that may instruct me on how I can use Matlab to:

Control and access the I2C hardware bus on the Roboard (get orientation data from HMC6352)

control and access the built-in A/D (capture the analog envelope output from ultrasound sensors)

Many thanks for your kind assistance!

Best Regards,
Andy

Statistics: Posted by wahooburger — Wed Mar 24, 2010 10:42 pm

RoboSavvy Forum

RoBoard and Matlab questions

RoBoard and Matlab questions