RoboSavvy Forum

Anyone using RoBoard RB-110 (newer version of RB-100) ?

2010-05-31T10:59:17+01:00

the RB-110 is almost same as RB-100, you can free to user same resource from RB-100

Statistics: Posted by roboard — Mon May 31, 2010 10:59 am

Anyone using RoBoard RB-110 (newer version of RB-100) ?

2010-05-29T20:47:09+01:00

roboard wrote:
One of the major features of RB-110 is that it has six COM ports, two of which are provided by the on-board FTDI FT2232H chip.
....

Are there any active discussion forums for the rb-110? I just picked one up and would like to absorb all i can without learning the hard way.

Statistics: Posted by Spiked3 — Sat May 29, 2010 8:47 pm

Anyone using RoBoard RB-110 (newer version of RB-100) ?

2010-04-16T08:40:21+01:00

Where and when can we buy it?

Statistics: Posted by siempre.aprendiendo — Fri Apr 16, 2010 8:40 am

Anyone using RoBoard RB-110 (newer version of RB-100) ?

2010-04-16T09:23:06+01:00

One of the major features of RB-110 is that it has six COM ports, two of which are provided by the on-board FTDI FT2232H chip.

RB-110 is designed for various AI servos with different serial speeds. The FT2232H allows max 12Mbps baudrate, and also allows flexible SPI & I2C access, which improves the drawback of RB-100's SPI interface.

The native COM ports (COM1~COM4) built in RB-110's CPU are also boosted to support max 750Kbps baudrate.

We have tested RB-110 on Bioloid AX-12+ servos; for reference, the results are listed as follows:

FT2232H COM ports with 1Mbps baudrate:

the average time for accessing an AX-12+ is about 2ms (by setting FT2232H's Latency Timer to 1ms).

RB-110's native COM ports with 115200bps baudrate:

the average time for accessing an AX-12+ is about 2ms. (This is interested; it is because the native COM ports have less latency delay in contrast to the USB FT2232H.)

RB-110's native COM ports with 500Kbps baudrate:

the average time for accessing an AX-12+ is about 1.2ms. (This is almost the minimum time to access an AX-12+ servos, because the responding time of AX-12+ is about 1ms.)

Statistics: Posted by roboard — Fri Apr 16, 2010 4:25 am

Anyone using RoBoard RB-110 (newer version of RB-100) ?

2010-04-09T04:28:43+01:00

it is not out yet
we will hopefully get a sample in a "couple" of months

Statistics: Posted by limor — Fri Apr 09, 2010 4:28 am

Anyone using RoBoard RB-110 (newer version of RB-100) ?

2010-04-07T23:16:42+01:00

Has anyone used the new RoBoard RB-110 (a newer version of the RB-100) ?

See
http://www.roboard.com/RB-110.htm

-John Elliott

Statistics: Posted by elliott — Wed Apr 07, 2010 11:16 pm