Re: using SRF05 with RoBoard

2010-08-16T10:35:34+01:00

For simplifying the usage and design of RoBoIO, rcservo_SendPWMPulses() and rcservo_Inp() cannot be used on the same channel at the same time.

Capture Mode is dedicated to PWM-based RC servos (such as KONDO's and HiTEC's PWM servos), and may not fit your purpose.

For your purpose, it is necessary to employ the low-level PWM lib and direct GPIO operations. You may refer to the source code of rcservo_ReadPosition_fast() in rcservo.cpp of RoBoIO src; it provides a similar implementation for you reference.

Statistics: Posted by roboard — Mon Aug 16, 2010 10:35 am

using SRF05 with RoBoard

2010-08-16T05:33:41+01:00

Hi,

I know, I should have bought the I2C version of the Ultra-Sonic sensors (SRF08 or SRF10) but I have not. The operation of the SRF05 (or SRF04) still is quite simple but I wonder which are the best library elements of the RB100 SW to use.

I connect the Trigger Input / Echo Output of SRF05 (Mode 2 - single pin) to one of the PWM ports (her channel 10) and intend to use the rcservo.h library. A sequence similar to this should do:

rcservo_Initialize(RCSERVO_USECHANNEL10);
rcservo_EnterPWMMode();
rcservo_SendPWMPulses(10, 15L, 14L, 1): // send 1 pulse of 15us to SRF05
while (!rcservo_IsPWMCompleted(10)); // wait until finished
while (in_value = rcservo_Inp(10) = 0); // check for rising edge of return signal
t1 = localtime(&tv.tv_sec); // will build a function to get system time in micro-seconds
while (in_value = rcservo_Inp(10) = 1); // check for falling edge of return signal
t2 = localtime(&tv.tv_sec); // will build a function to get system time in micro-seconds

pulse_length = t2 - t1; // return signal length in micro-seconds

Would you please comment if that would work with enough accuracy to determine the object's distance? To improve statistics I could put the measurement into a loop to repeat say 10 times.

I wonder if any of the servo commands in "Capture Mode" could be used to determine the return signal's pulse length?

Best regards,

Marsman

Statistics: Posted by Marsman — Mon Aug 16, 2010 5:33 am

RoboSavvy Forum

Re: using SRF05 with RoBoard

using SRF05 with RoBoard