ROBOIO lib

2012-02-10T08:59:06+01:00

If you had initialized roboio.rcservo, then you want to change one pin to

another mode, you should close roboio.rcservo (rcservo_Close) and initialize it

(rcservo_Init) again.

Statistics: Posted by roboard — Fri Feb 10, 2012 8:59 am

ROBOIO lib

2011-12-02T00:15:51+01:00

What libraries must i close when i use roboio.rcservo ? At the start of my program i open the spi,i2c and rcservo. At a point in my program i must close and open a gpio port and it says that i cannot both use RCSERVO and PWM lib at the same time.
Thanks for the help!

Statistics: Posted by hellu — Fri Dec 02, 2011 12:15 am

RoboSavvy Forum

ROBOIO lib

ROBOIO lib