RoboSavvy Forum

HeartToHeart3

2007-02-02T04:07:39+01:00

I've quite happily been using the HTHJ_E version of the software with my KHR-1HV and havent found any anomalies yet. The H2H3 I've got is in Japanese and although one or two of the dialogs have more options I them, I cant read them as all I get is '??????????????'

Im hoping there is nothing radical I'm going to run into later but by then there may be an English version published.

Statistics: Posted by PaulP — Fri Feb 02, 2007 4:07 am

HeartToHeart3

2007-01-27T01:58:03+01:00

Robo1 wrote:
hello

I was looking on the kondo site about the khr-1HV (new one) and it had a table comparing the software and it said H2HJ for KHR-2 and H2H3 for KHR-1HV. I just wanted to have a look and see if it was any different and if it any other features.

bren

Good question.

The difference is in the controller - RCB3 vs. RCB3J and has to do with support of some of the KRS-4000 series servo modes that aren't used in the KHR-2HV bot.

Statistics: Posted by tempusmaster — Sat Jan 27, 2007 1:58 am

HeartToHeart3

2007-01-26T17:33:23+01:00

hello

I was looking on the kondo site about the khr-1HV (new one) and it had a table comparing the software and it said H2HJ for KHR-2 and H2H3 for KHR-1HV. I just wanted to have a look and see if it was any different and if it any other features.

bren

Statistics: Posted by Robo1 — Fri Jan 26, 2007 5:33 pm

Re: HeartToHeart3

2007-01-26T15:40:01+01:00

Robo1 wrote:
Can some one please post H2H3.

do you think it will work for the KHR-2?

Thanks bren

Bren,

I'm curious about how you want to use it.

H2H3J comes with the KHR-2HV kit and both the Japanese and English versions can be downloaded from the Kondo website. So, I'm a little confused by your request.

Statistics: Posted by tempusmaster — Fri Jan 26, 2007 3:40 pm

HeartToHeart3

2007-01-26T14:55:04+01:00

Can some one please post H2H3.

do you think it will work for the KHR-2?

Thanks bren

Statistics: Posted by Robo1 — Fri Jan 26, 2007 2:55 pm