RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2006-09-20T05:27:48+01:00 http://forum.robosavvy.com/feed.php?f=2&t=599 2006-09-20T05:27:48+01:00 2006-09-20T05:27:48+01:00 http://forum.robosavvy.com/viewtopic.php?t=599&p=3797#p3797 <![CDATA[KHR-2HV USB WIRELESS]]> Do we need an extra battery to plug into the reciever or not?
I have tried uninstall and install many time still doesn't work.

Statistics: Posted by animetown9 — Wed Sep 20, 2006 5:27 am

]]> 2006-09-14T20:55:55+01:00 2006-09-14T20:55:55+01:00 http://forum.robosavvy.com/viewtopic.php?t=599&p=3706#p3706 <![CDATA[KHR-2HV USB WIRELESS]]> there is one lead with just a signal and earth wire, another with earth and positive and the final one combines two leads into one.

on the processor board there is an input for rx
i assume thats for the reciever
aside from installiing drivers and plugging rx in, is there anything else i have to do to enable the wireless?

from what i can gather the extra leads may be for interfacing into the KHR-1 processor boards but am unsure.

btw i have installed drivers and pluged rx into board - nothing :roll:
yes i have confirmed that i was using the correct com port
i am not sure if i should run the remove all driver script and reinstall wireless drivers only? i have both ports and they seem ok, but only serial one from computer seems to work.
maybe something software side?

all help as always greatly appreciated

Statistics: Posted by fatman — Thu Sep 14, 2006 8:55 pm

]]>