RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2011-03-21T19:26:36+01:00 http://forum.robosavvy.com/feed.php?f=22&t=7082 2011-03-21T19:26:36+01:00 2011-03-21T19:26:36+01:00 http://forum.robosavvy.com/viewtopic.php?t=7082&p=30586#p30586 <![CDATA[Wild Thumper 4WD Pack]]>
The red and black gives power to the receiver
The yellow and the green transmits the PWM from the receiver to the arduino board.

Image

Statistics: Posted by nunogato — Mon Mar 21, 2011 7:26 pm

]]> 2011-03-21T18:04:38+01:00 2011-03-21T18:04:38+01:00 http://forum.robosavvy.com/viewtopic.php?t=7082&p=30582#p30582 <![CDATA[Wild Thumper 4WD Pack]]>
A good starting point is reviewing the product page of each component individually, in particular these:

Wild Thumper: http://robosavvy.com/store/product_info ... ts_id/1176
Arduino Controller: http://robosavvy.com/store/product_info ... ts_id/1168

You then need to download the sample code in the bottom of this page http://robosavvy.com/store/product_info ... ts_id/1236 and download it to the Arduino Controller.

If you have a fair understanding of Arduino you can look in the code to understand what pin does what.

My colleague Nuno will make a post here, in reply to your question, in the next hours explaining which pin goes where to completelly answer your question. (fyi pin 1 and 2 of the Arduino control the direction and speed).
I'm just anticipating him to let you know we're looking into your question and giving you some preliminary information.

Should you need, we are also available by email on support@robosavvy.com.

Regards
Pedro.

Statistics: Posted by PedroR — Mon Mar 21, 2011 6:04 pm

]]> 2011-03-20T14:34:40+01:00 2011-03-20T14:34:40+01:00 http://forum.robosavvy.com/viewtopic.php?t=7082&p=30565#p30565 <![CDATA[Wild Thumper 4WD Pack]]> I just got this Wild Thumper 4WD Pack as a gift but is there somewhere somekind of manual how to connect receiver to motor controller etc?

Statistics: Posted by jkaskinen — Sun Mar 20, 2011 2:34 pm

]]>