I'm using a wildthumper board, but I can't upload a new program in it. I've read this post: http://letsmakerobots.com/node/31728#comment-82021 so I know that I've got to burn the bootloader.
I've read this page: http://arduino.cc/en/Hacking/Bootloader where explain how I must do it. Unluckily I don't have a AVR-ISP, USBtiniISP or another arduino board neither, so I've thought construct a parallel programmer as say the following page: http://arduino.cc/en/Hacking/ParallelProgrammer.
The point is: Could I use the parallel programmer to burn the bootloader in the wildthumper?? and if I can, Where must I connect the parallel programmer?? maybe in the ISP port?? and How is the correct conexion?? i.e. wich pin is the "pin 1" how we can see in the figure who is here--> http://arduino.cc/en/Hacking/ParallelProgrammer.
Thank you for your time and your attention.ld see in the figureStatistics: Posted by pinguino_vikingo — Thu May 03, 2012 9:48 am
]]>