RoboSavvy Forum

Robby my 3d printed DARwIn-OP

2013-05-05T16:53:11+01:00

Here is a link to my Make magazine article.

http://blog.makezine.com/2013/04/26/clo ... darwin-op/

Statistics: Posted by Gort — Sun May 05, 2013 4:53 pm

Robby my 3d printed DARwIn-OP

2013-05-02T18:32:09+01:00

I am using the Fitpc2 and CM-730. I bought the electronics kit.

I am learning how to use all of the DARwIn software tools.

I am having issues with MX-28s out of the box, They are not calibrated correctly. I am going to work on that this weekend.

Statistics: Posted by Gort — Thu May 02, 2013 6:32 pm

Robby my 3d printed DARwIn-OP

2013-05-01T09:41:09+01:00

that's incredible!

seeing these flimsy 3D printed brackets actually sustaining the torques and hardship of MX28 servos and full weight of the upper body... defies intuition.

Are you using the original embedded intel PC kit for Darwin or some other PC?

Have you tried the Darwin gait generator ?

Statistics: Posted by limor — Wed May 01, 2013 9:41 am

Robby my 3d printed DARwIn-OP

2013-04-30T22:53:43+01:00

The printing and assembly is done.

I just need to calibrate a few servos and tune the walking gait!!

http://mike-ibioloid.blogspot.com/2013/ ... close.html

Statistics: Posted by Gort — Tue Apr 30, 2013 10:53 pm