RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2007-03-16T09:14:17+01:00 http://forum.robosavvy.com/feed.php?f=3&t=61 2007-03-16T09:14:17+01:00 2007-03-16T09:14:17+01:00 http://forum.robosavvy.com/viewtopic.php?t=61&p=8068#p8068 <![CDATA[New Motion Processor Japanese Manual]]>
ryann2k1 wrote:
Hi limor,
Do you think this board is capable of being connected to any sensor?
I could not read Japanese. :(
ryann2k1

The good news - yes, it can be used with a wide range of sensors, has a lot more sensor ports, and features a fairly robust scripting language. It's used by quite a few of the top ROBO-ONE competitors including Sugiura (Dynamizer), Maru (King Kizer), etc.

The bad news - because of the price and the lack of English documentation, it hasn't sold well, if at all, outside of Japan. And, since it's about two years old now, it's likely to be replaced by something better sooner rather than later.

Statistics: Posted by tempusmaster — Fri Mar 16, 2007 9:14 am

]]> 2007-03-16T08:39:14+01:00 2007-03-16T08:39:14+01:00 http://forum.robosavvy.com/viewtopic.php?t=61&p=8065#p8065 <![CDATA[New Motion Processor Japanese Manual]]>
Do you think this board is capable of being connected to any sensor?
I could not read Japanese. :(

cheers

ryann2k1

Statistics: Posted by ryann2k1 — Fri Mar 16, 2007 8:39 am

]]> 2005-06-29T21:15:33+01:00 2005-06-29T21:15:33+01:00 http://forum.robosavvy.com/viewtopic.php?t=61&p=249#p249 <![CDATA[New Motion Processor Japanese Manual]]> Motion Processor. A successor/alternative to RCB-1.
Image

It was designed by Himeji Soft Works Co. who make some interesting humanoid designs and controler boards and recently are also into dressing up robots as dolls.
Image
In case you can read Japanse, here'sthe operations manual for the new controler.

Statistics: Posted by limor — Wed Jun 29, 2005 9:15 pm

]]>