RoboSavvy Forum

Comminication errors

2006-03-21T01:18:46+01:00

I found that the communication cable plug had excess plastic around the shaft that plugs in the the control board, and the plug was not seating fully. By carefully trimming 1/2 mm from the base of the plug I now get consistent communications.

Good luck,

JM

Statistics: Posted by Guest — Tue Mar 21, 2006 1:18 am

Robonova Communication Problem

2006-03-15T06:56:52+01:00

I noticed if I have any tension on the cable, it fails even if everthing looks secure.

Statistics: Posted by bauermech — Wed Mar 15, 2006 6:56 am

Robonova Communication Problem

2006-03-15T06:45:59+01:00

Try Truning it on and off also try unplugging the serial connector and putting it back on. Make sure the ground part of the phono jack touches metal of the port.

Statistics: Posted by RubikCube — Wed Mar 15, 2006 6:45 am

Robonova Communication Problem

2006-03-15T03:06:41+01:00

My robonova fail to download new application, but get retriev Controller info or even Realtime Controller. I got Error -5 , Does anyone know to solve this problem. ?

Statistics: Posted by Uthai — Wed Mar 15, 2006 3:06 am