RoboSavvy Forum

Simple sensor recommendation

2006-03-19T16:19:58+01:00

Thanks! Im gonna give it a try too, most appreciated

Statistics: Posted by crmfghtr — Sun Mar 19, 2006 4:19 pm

Simple sensor recommendation

2006-03-18T23:45:13+01:00

The gyro implementation actually takes 2 of the AD ports. One for input to the gyro and one for output from the gyro. These are detailed on page 138 of the RoboBasic manual.

Right now I am unaware of anyone who has implemented a gyro yet but I am awaiting delivery of mine so will update the forum as I move forward.

Hope that helps

Pev
PS sorry to thread hijack again subpilot but wanted to answer the gyro question

Statistics: Posted by Pev — Sat Mar 18, 2006 11:45 pm

Simple sensor recommendation

2006-03-19T02:48:34+01:00

I haven't done any experiments with gyros and can't really comment other than I would think that would be a more advanced control problem and the RC gyros I've seen are fairly large.

Statistics: Posted by subpilot — Sat Mar 18, 2006 11:22 pm

Simple sensor recommendation

2006-03-18T22:32:31+01:00

Perfect just the start i needed thankyou i will gather the bits and report soon.Which socket would you plug a gyro in ??

Statistics: Posted by rep001 — Sat Mar 18, 2006 10:32 pm

Simple sensor recommendation

2006-03-18T22:05:20+01:00

Here's a cheap and simple way for people to get started with adding external sensor functions. Pick up a Sharp GP2D120 Infrared sensor http://www.acroname.com/robotics/parts/ ... 2D120.html
It has an analog voltage output representing the range from the front of the sensor to an object. All you have to do is add a plug and plug it in to an unused analog port.
For the board connector I use Digikey part# WM2801 with WM2555 pins.
http://rocky.digikey.com/scripts/Produc ... 50-57-9003
You can use a Radio Shack crimper to do the pins if you're careful but I recommend getting a Universal Crimp Tool (Molex)
Wire the connector with the red wire in the center and the black and yellow wires in the other two holes. Plug the connector into port AD0 (see page 42 of the manual) with the yellow wire inboard and the black wire outboard.

Here's a bit of code to make the robot backup if he senses something in the sensor range.

a=AD(0)
IF a > 100 THEN GOSUB k12

You can add more sensors and just plug them into more AD ports. Note that AD6 is used for battery voltage sense and AD7 is used for the IR link.

Statistics: Posted by subpilot — Sat Mar 18, 2006 10:05 pm