RoboSavvy Forum

Error 26 on Robonova...

2008-01-07T20:50:34+01:00

k, problem solved. the thing was in contacts of charger,inside it.they were kind melted,so i just cleaned em and it works well now.
But i still like to know error codes explanation:)

Statistics: Posted by Sazabi — Mon Jan 07, 2008 8:50 pm

Error 26 on Robonova...

2008-01-07T15:01:39+01:00

Yeah,I did,doesn't help.
But now problem half-sold: i tried on PC with normall, build-in COM port(serial) and it works great.
But....feels like battery is low,cause robo moves only half a figure(
And my charger doesn't work on those plugs, where other electric stuff do. No idea why((

Statistics: Posted by Sazabi — Mon Jan 07, 2008 3:01 pm

Error 26 on Robonova...

2008-01-07T11:09:46+01:00

In the port setting window, did you try setting the communication over time slider to slow ?

Statistics: Posted by i-Bot — Mon Jan 07, 2008 11:09 am

Error 26 on Robonova...

2008-01-07T09:14:15+01:00

Hello!
Trying to wright some data in my robo, but this error goes out and robo turns off, than turns on again.
Problem can appear in the beginning,in the middle or in the almost end of downloading.
Once i downloaded programme successfull,but only once.
Everything else works well, like controller info or realtime servo managment.
I use COM->USB translator, speed 115k.
is there any place to read about error codes?
Gonna try on PC with normal Serial port today,hope it will work

Statistics: Posted by Sazabi — Mon Jan 07, 2008 9:14 am