RoboSavvy Forum

RN-1 Schematic for Serial cable???

2008-10-29T10:42:22+01:00

Here is a diagram of Robonova vs. Bioloid serial cable configuration.

I recall the hours spent trying to figure out why serial communications was not working when eventually it turned out to be a Bioloid / Robonova serial cable mixup.

Statistics: Posted by limor — Wed Oct 29, 2008 10:42 am

RN-1 Schematic for Serial cable???

2008-10-17T13:06:56+01:00

you welcome:)

Statistics: Posted by Sazabi — Fri Oct 17, 2008 1:06 pm

Thanks

2008-10-17T12:53:51+01:00

Hey..
I'll make one up tomorrow!
Hope that fixes my "dead" RN-1 when I reload his schedule.
Thanks for the quick reply!
Dave

Statistics: Posted by dstrass — Fri Oct 17, 2008 12:53 pm

RN-1 Schematic for Serial cable???

2008-10-17T12:50:00+01:00

looking on the DB9 plug (female) from the side, which plugs in PC (or just use numbers on that plug:D), top row, right to left:
2 - middle one on audio jack
3 - very first part on audio jack (most far from the side cable is soldered to)
5 - very rear part on jack(ground, nearest to cable)

Statistics: Posted by Sazabi — Fri Oct 17, 2008 12:50 pm

RN-1 Schematic for Serial cable???

2008-10-17T06:50:02+01:00

Hey,
Left my cable in US.
I'm in Australia.
Doesn't look like there's a dealer here.
Anyone know the schematic to the serial cable to 1/8" jack so I can make up my own?
My Robonova turns on, blue light blinks, but no signal to servos.
I'm guessing a reload of the schedule will do the trick.

Anybody know the pins out to the 1/8" stereo plug?
Thanks,
Dave

Statistics: Posted by dstrass — Fri Oct 17, 2008 6:50 am