RoboSavvy Forum

Battery voltage

2008-11-24T16:35:13+01:00

The battery monitor was solved recently for nearly all robots. If you want to know how, and see the circuit, there's a generic article that you can find in Penguin Tech Magazine issue #3. This method is amazingly accurate and can be calibrated up to the full voltage of the battery, down to a low voltage just before circuits and servos begin to fail. Software is free at the download sites, and can be modified for Robonova.

http://forums.parallax.com/forums/defau ... 0&m=303010
http://www.robotinfo.net/penguin/

humanoido

Statistics: Posted by Humanoido — Mon Nov 24, 2008 4:35 pm

Battery voltage

2008-11-17T03:27:52+01:00

Well your are going to need hardware and if I was you I would start to consider if you were going about the problem of the driving UAV in the right way. Nicads do not have a gradual voltage reduction as they discharge and by the time you get to the discharge knee the processor board is on the verge of stopping working because it isn't getting enough voltage. You at least need to replace the on board voltage regulator with a very low drop-out one or run the processor from a separate supply.
David

Statistics: Posted by robots42 — Mon Nov 17, 2008 3:27 am

Battery voltage

2008-11-16T17:40:16+01:00

It is crucial for me to check the MRC voltage as the MOBO drives my UAV.

Will look around to find a solution, thanks !

Statistics: Posted by roboTT — Sun Nov 16, 2008 5:40 pm

Battery voltage

2008-11-13T23:42:47+01:00

Hi
I think the resistors are missing from the PCB because you can't reliably measure the battery voltage as it is going flat, see
http://davidbuckley.net/RS/RoboNova/RoboNovaLV.htm
and
http://www.davidbuckley.net/DB/RoboNova ... ircuit.htm
Also I don't see why you need to shut down RN. If the battery is flat RN just stops moving. You don't have to worry about deep discharging the battery, it is not Lithium Polymer so it doesn't matter. You can see RN isn't working and switch it off.
The way the US navy stores NiCad batteries is dead flat with copper shorting bars across them. Running NiCads right down is good for them.
David

Statistics: Posted by robots42 — Thu Nov 13, 2008 11:42 pm

Battery voltage

2008-11-11T12:18:22+01:00

Robofreaks!

How can i check the voltage on battery without installing addtional 'hardware' and forging anything?

I'm not a kind of electrician, just a programmer

Please tell me it's possible to check the voltage of battery without playing with the hardware too much...

Just wanted to prevent my RN1 from doing actions when battery goes to 'low level'..

Statistics: Posted by roboTT — Tue Nov 11, 2008 12:18 pm