Zero setting out of limits

2010-05-06T11:04:13+01:00

Can you not simply rotate the mounting on the servo disk by 90 degrees ?

Statistics: Posted by i-Bot — Thu May 06, 2010 11:04 am

Zero setting out of limits

2010-05-06T10:04:32+01:00

Hi, The servo range in the zero point setting module in RoboBasic has a "soft" range bound (50-150). I am not able to move beyond and this is required to get the zero setting right. I can get the full range using the real-time servo control and import into RoboBasic program but not into the zero setting. What is the solution ? Am a little frustrated with the software limiations.
Mowgli Nicobarian

Statistics: Posted by mowgli_nicobarian — Thu May 06, 2010 10:04 am

RoboSavvy Forum

Zero setting out of limits

Zero setting out of limits