Problem with Torque Limit

2007-11-11T14:09:54+01:00

When you use the bioloid program to play pages it sets the torque to 0 and the speed to 0x3ff.

Statistics: Posted by Bullit — Sun Nov 11, 2007 2:09 pm

Problem with Torque Limit

2007-11-10T23:23:59+01:00

I am having trouble with the torque on one of my AX-12's. The torque limit (34/35 in the control table) is set to 0. The max torque in the EEPROM (14/15 in the control table) is set to 1023. If I am reading the manual correctly, the torque limit in RAM is updated from the value in EEPROM when powered on.

I have tried writing 1023 to the RAM but it still stays at zero. It has me puzzled. Does anyone happen to have some suggestions?

Thank you.

Shawn

Statistics: Posted by shunt2000 — Sat Nov 10, 2007 11:23 pm

RoboSavvy Forum

Problem with Torque Limit

Problem with Torque Limit