RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2008-02-09T12:22:44+01:00 http://forum.robosavvy.com/feed.php?f=5&t=2211 2008-02-09T12:22:44+01:00 2008-02-09T12:22:44+01:00 http://forum.robosavvy.com/viewtopic.php?t=2211&p=14068#p14068 <![CDATA[Recovering Hex file with Behavior Control Programmer]]>
I tried yesterday to recover the hex file of the CM-5 as I loaded one into it and could not connect to the CM-5 at all.

After some hours of trying it with the Robot Terminal and following the guidelines in the forum I finally downloaded the new Bioloid software 1.10.

Included is the Behavior Control Programmer 1.23

And in this version there is a new functionality which was missing in the older version.

If you go to MANAGEMENT and then hit RECOVERY CM-5 you are guided through a menue and the CM-5 is then updated to any hex file you want. It took 1 minute or so and then it worked.

Best wishes

Andi

Statistics: Posted by Andi — Sat Feb 09, 2008 12:22 pm

]]>