RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2008-02-14T23:57:51+01:00 http://forum.robosavvy.com/feed.php?f=5&t=2228 2008-02-14T23:57:51+01:00 2008-02-14T23:57:51+01:00 http://forum.robosavvy.com/viewtopic.php?t=2228&p=14144#p14144 <![CDATA[Kill a dynamixels ?]]> http://robosavvy.com/forum/viewtopic.php?t=2150

Statistics: Posted by Rob — Thu Feb 14, 2008 11:57 pm

]]> 2008-02-14T21:30:08+01:00 2008-02-14T21:30:08+01:00 http://forum.robosavvy.com/viewtopic.php?t=2228&p=14143#p14143 <![CDATA[Re: Kill a dynamixels ?]]>
boutboutnico wrote:
Hi all,
Is it possible to kill a dynamixel? I have no answer from this one. I have try to reset the ax-12, set a new ID check wire connector etc...
Help is welcome
Nico


From another thread you said there was error 8100

Well, from the user's manual:

Code = 8100
Meaning = Access to the unavailable Dynamixel ID
Check Point = Check whether an using ID of AX-12+ or AX-S1 that does not exist ist in robot. Check the cutting line

You can download this manual from:

"http://211.238.207.44/~robotis/ROBOTIS/Manual/BioloidUsersGuide(ver1-1)EN.zip"

The other more common problem is have changed unintentionally baud or id parameters from one or more AX12+

Statistics: Posted by siempre.aprendiendo — Thu Feb 14, 2008 9:30 pm

]]> 2008-02-14T19:43:37+01:00 2008-02-14T19:43:37+01:00 http://forum.robosavvy.com/viewtopic.php?t=2228&p=14140#p14140 <![CDATA[Kill a dynamixels ?]]> Is it possible to kill a dynamixel? I have no answer from this one. I have try to reset the ax-12, set a new ID check wire connector etc...
Help is welcome
Nico

Statistics: Posted by boutboutnico — Thu Feb 14, 2008 7:43 pm

]]>