RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2008-05-25T07:30:57+01:00 http://forum.robosavvy.com/feed.php?f=5&t=2592 2008-05-25T07:30:57+01:00 2008-05-25T07:30:57+01:00 http://forum.robosavvy.com/viewtopic.php?t=2592&p=16017#p16017 <![CDATA[Humanoid...Invalid Page Read:0001]]>
http://robosavvy.com/forum/viewtopic.php?t=2579

This problem is the absence of motion data in the CM-5 memory. Upload the motion data and all will be well.

Statistics: Posted by StuartL — Sun May 25, 2008 7:30 am

]]> 2008-05-24T23:54:41+01:00 2008-05-24T23:54:41+01:00 http://forum.robosavvy.com/viewtopic.php?t=2592&p=16011#p16011 <![CDATA[Humanoid...Invalid Page Read:0001]]> http://robosavvy.com/forum/viewtopic.ph ... valid+read

could it be that you have a fuse problem ?

Statistics: Posted by limor — Sat May 24, 2008 11:54 pm

]]> 2008-05-24T20:42:43+01:00 2008-05-24T20:42:43+01:00 http://forum.robosavvy.com/viewtopic.php?t=2592&p=16007#p16007 <![CDATA[Humanoid...Invalid Page Read:0001]]>
After this i tried to run the DemoExample and am getting the following message

It reads all of the dynamixles then says the following:

019(0X13) Dynamixles found. [Invalid Page Read:0001]

When i his L which is supposed to enter fighting stance the robot reads:

Invalid Page Read: 002A or 002B depending on the side I put my hand...It does this about 100 times

any help would be appreciated

Statistics: Posted by Help — Sat May 24, 2008 8:42 pm

]]>