RoboSavvy Forum

Re: help me out

2008-09-01T00:21:24+01:00

NEVER wrote:
how can i compile the c example ???

google AvrGCC.
but use the libraries that have been written already and published here

Statistics: Posted by limor — Mon Sep 01, 2008 12:21 am

help me out

2008-08-31T21:21:23+01:00

how can i compile the c example ???

Statistics: Posted by NEVER — Sun Aug 31, 2008 9:21 pm

beginners question

2008-08-08T17:54:03+01:00

Try sending the reset packet, you should then get the AX12+ on ID 1 with the factory settings, hopefully it'll improve your situation.

If you're feeling more adventurous you can explore it a little bit by sending '#' repeatedly at 57600 baud down the 1Mbit bus, listening for any bytes back at the same baud. Then reset/power up the servo. You'll hit the bootloader and be able to reset the EEPROM etc from there. Default EEPROM values are all 0xFF.

Statistics: Posted by StuartL — Fri Aug 08, 2008 5:54 pm

beginners question

2008-07-29T17:22:13+01:00

if anyone could help with this one...

my ax12+ are not giving me feedback when i ping them. I hooked the signal up to the o'scope and it is a delay of 1 ms, way too much right. I read the ax12 manual and the delay should be 160 microsec. i need my delay to be small so my board can read it. however i am having trouble writing to address 5, where return delay time is written. any suggestions? basically there is still no return signal still.

Thanks,

Emily

Statistics: Posted by roboChick0111 — Tue Jul 29, 2008 5:22 pm

beginners question

2008-07-29T15:47:26+01:00

oh I figured it out. needed to change administrator settings.

Statistics: Posted by roboChick0111 — Tue Jul 29, 2008 3:47 pm

beginners question

2008-07-29T14:14:07+01:00

Hello All,

I just got my cm2plus and some RX-64s. I was communicating to the the cm2plus through my terminal window. However, when I tried running the behavior control program, I get:

Cannot connect CM-5 !
Please check the condition of connection.

I clicked on the red check and my code is safe.

Thanks.

Emz

Statistics: Posted by roboChick0111 — Tue Jul 29, 2008 2:14 pm