RoboSavvy Forum

really stuck, advice needed please...

2008-12-03T08:23:43+01:00

Have you got one of the servos 90 degrees out?

Statistics: Posted by StuartL — Wed Dec 03, 2008 8:23 am

positive result

2008-12-02T23:09:31+01:00

I have just got the droid to walk, downloaded the demo program but didnot press the play from PC putton, ran from the CM5 and OK, anyone got any ideas why it wont run from PC
got a bit excited when it walked - well until the screws fell out of it leg and it fell over, at least I know how to twist a screwdriver...

Statistics: Posted by shergy — Tue Dec 02, 2008 11:09 pm

still stuck

2008-12-02T22:19:06+01:00

Ok, started again, loaded check program, all OK and each led lights up correctly., loaded Demo example program and the walker ties its self up.
Loaded motion editor, pose 0 OK, pose 1 feet jam and walker falls over, power down CM5 pose 2 3,4 5 OK, Pose 6 jams legs

Statistics: Posted by shergy — Tue Dec 02, 2008 10:19 pm

really stuck, advice needed please...

2008-12-02T19:25:56+01:00

JavaRN wrote:
Did you load the motion files before trying the behaviour programs?

This looks like it may be a good start - have you done this?

Statistics: Posted by StuartL — Tue Dec 02, 2008 7:25 pm

help needed

2008-12-01T23:55:42+01:00

I loaded the check servo program - ran it, all checks OK, loaded the walker program, ran it - (servos locked), powered off the CM-5, then loaded the behaviour program.
I forgot to mention that I have taken it apart and rechecked everything, same result.

Statistics: Posted by shergy — Mon Dec 01, 2008 11:55 pm

really stuck, advice needed please...

2008-12-01T21:41:06+01:00

Did you load the motion files before trying the behaviour programs?

Statistics: Posted by JavaRN — Mon Dec 01, 2008 9:41 pm

really stuck, advice needed please...

2008-12-01T21:23:53+01:00

Hi could anybody give a newbie some advice, I have had the bioloid for some time but only had success with the very basic robots, I have just built the walking droid, it tries to walk but after a few seconds crosses it feet and locks up, the test program is all OK, when I load the behavious program and go through the stages all are OK until it get to the last, instead of returning to a neutral position it locks its feet. I checked the alighment of all servos and all were as should be, dont know what else to try... help.....
The clappink penguin would not clap but, Greeting penguin would not greet etc etc...
The first 8 basic robots were fine

Statistics: Posted by shergy — Mon Dec 01, 2008 9:23 pm