Running AX and RX together?

2008-12-24T14:16:12+01:00

The two servos use a different bus architecture, although the protocol is the same. This means that you could run two busses, one for RX and one for AX and either have a level converter (RX is RS-485, AX is TTL serial) or two separate serial interfaces on your controller.

Statistics: Posted by StuartL — Wed Dec 24, 2008 2:16 pm

Running AX and RX together?

2008-12-24T06:26:23+01:00

Hi,

I have a doubt here...is it possible to control AX and RX serise Dynamixel servos together using USB2Dynamixel?....Will there be any issues doing it?

Statistics: Posted by rikkov — Wed Dec 24, 2008 6:26 am

RoboSavvy Forum

Running AX and RX together?

Running AX and RX together?