RoboSavvy Forum

Thanks

2009-08-31T21:24:53+01:00

hey Darkback2!

I was cheking your anwer and it work!

A have to solder at ZIG2SERIAL the R7 and R10, and conect a wire a 5 volts power source to the zig2serial using my converter wire DB9-USB and that's all.... Now a can comunicate whit my bioloid thanks!

Statistics: Posted by Beny!! — Mon Aug 31, 2009 9:24 pm

ZIG2SERIAL Y ZIG-100

2009-08-19T06:37:53+01:00

Hello Darkback2!!! Thanks by your help!

I try to do it tomorrow... I am checking the URL... thanks again

Statistics: Posted by Beny!! — Wed Aug 19, 2009 6:37 am

Zig2Serial Zig100

2009-08-18T21:45:29+01:00

Hey Beny,

I just ran into the same problem.

The zig100/zig2serial expect to receive power (5volts) on pin 9 through the serial port of the computer.

The easiest way to accomplish this is to use the usb2dynamixel adaptor. a second method is to wire a 5 volt power source to the zig2serial.

This requires that you modify the zig2serial. http://forums.trossenrobotics.com/showthread.php?t=1233&highlight=zig2serial Check that out and see if it helps.

Once you have the Zigbee up and running you shoul dnot it is not a drop in solution. You can talk to it using the following protocal.

http://robosavvy.com/forum/viewtopic.php?t=1395

I hope you find all of this helpful.

DB

Statistics: Posted by Darkback2 — Tue Aug 18, 2009 9:45 pm

ZIG2SERIAL Y ZIG-100

2009-08-17T17:23:20+01:00

HI everybody

I need your help, i am new in this topic, i have the advance kit bioloid and i try to conect the zig2serial in my PC, i am using a wire USB-SERIAL(DB9) to conect it but the zig2serial don't turn on, don't do anything!! i am not using USB2DYNAMIXEL is necesary use it? i don't know very well but the zig2serial need input energy apart?? i mean, i must conect it 5 volts to work correctly...? and i hear something like i need to conect some resistor or something like that...

I hope you can help me!

Statistics: Posted by Beny!! — Mon Aug 17, 2009 5:23 pm