RoboSavvy Forum

AVR32 Bioloid Controller

2009-12-23T11:03:45+01:00

I have not done anything on the AP7000 AVR32, so I am not sure if the files I use under the Atmel software framework also work for that as well as the smaller processors.

Anyway the c code is here:
http://robosavvy.com/Builders/i-Bot/dxmaster.zip

Statistics: Posted by i-Bot — Wed Dec 23, 2009 11:03 am

AVR32 Bioloid Controller

2009-12-23T01:07:50+01:00

Hi,

I'm using the IC-Board (http://www.ic-board.de/product_info.php ... erKit.html) with the AVR32 Controller. I want to use it to control a few AX-12 Servos with this controller. So I want to ask if you could send me your code to control the AX-12?

Best regards,
Psykoman

Statistics: Posted by Psykoman — Wed Dec 23, 2009 1:07 am

AVR32 Bioloid Controller

2009-10-26T13:14:29+01:00

I have been working with one of the first batch of MM-AVR32 boards from RandomMatt with a 60MHz 32 bits AVR32 processor. I hope Matt will tell you more about the board itself.

I have packaged mine to access all the ports and added a small sub board to give USB otg power switching and EEPROM.

The software is developed in Atmel AVR32 Studio in C and uses an expansion of the AVR32 software framework for the built in dynamixel bus and accelerometer. I run under FreeRTOS, but it is not absolutely necessary. The firmware is downloaded using in built USB firmware upgrade. The USB port operates in both device and host mode. In device mode it is currently programmed to be a serial CDC device. In host mode it connects to a USB bluetooth dongle. The bluetooth currently only supports Wiimote and PS3, but I hope to get serial working too.

Because the USB connector is mini otg, I have to use an adapter for the cheap bluetoth dongle. Anybody know of an mini otg bluetooth ?

Statistics: Posted by i-Bot — Mon Oct 26, 2009 1:14 pm