RoboSavvy Forum

y

2010-09-14T09:29:14+01:00

yup that will do. I tent to use a cutter knife.

Statistics: Posted by UncleBob — Tue Sep 14, 2010 9:29 am

I found this issue during construction of my bioloid.

2010-09-09T21:58:42+01:00

27Loco,

Thanks for the feedback!

Statistics: Posted by Gort — Thu Sep 09, 2010 9:58 pm

I found this issue during construction of my bioloid.

2010-09-09T10:05:51+01:00

I also used a longer screw to pull the nut up. I will try your method, thanks for sharing!

EDIT: It works

Statistics: Posted by 27Loco — Thu Sep 09, 2010 10:05 am

I found this issue during construction of my bioloid.

2010-09-09T06:09:29+01:00

I had the same problem with some of my AX-12 servos. Thank you for sharing your fast and easy method to fix this problem.

Statistics: Posted by helishaun — Thu Sep 09, 2010 6:09 am

TIP FOR YOU!

2010-09-09T02:49:49+01:00

Here's a tip you can use.
Simply use your finger to put the screw in place,
and use the screw driver to fasten without any pressure.

If the nut falls out of place, use a longer screw to fasten the nut then pull it up.

Statistics: Posted by kayla — Thu Sep 09, 2010 2:49 am

I found this issue during construction of my bioloid.

2010-09-09T00:22:14+01:00

Here is the problem.

phpBB [media]

Here is my solution:

phpBB [media]

full post on my blog:
http://mike-ibioloid.blogspot.com/2010/ ... oloid.html

Statistics: Posted by Gort — Thu Sep 09, 2010 12:22 am