RoboSavvy Forum

Center Line for AX-12+

2010-09-20T10:16:29+01:00

When you dismanted the robot did you remove the servo output disk from the servo output shaft by removing the central screw ?
If so you may have put it back in a different position.
Simply measure the error, remove the servo and central screw without moving disk, and put disc to correct alignment.
Or use servo manager to set a central 512 position and align the mark on the disc.

Statistics: Posted by i-Bot — Mon Sep 20, 2010 10:16 am

Center Line for AX-12+

2010-09-20T09:04:24+01:00

Do you mean servo ID, I did not change the ID and checked is correct for the ID. Any other setting i need to do after dismantle from one model?

Statistics: Posted by BernardAR — Mon Sep 20, 2010 9:04 am

Center Line for AX-12+

2010-09-17T17:23:17+01:00

Do you have this problem with all the servos? It's very strange...

May be you have change the servo settings. Have you checked it?

Statistics: Posted by siempre.aprendiendo — Fri Sep 17, 2010 5:23 pm

Center Line for AX-12+

2010-09-17T09:37:13+01:00

Yes, exactly. I'm not a programmer, but very intereted about robot.
I manually turn it to line up the position already but is wrong after fully assemble.
Please help and hopefully is not difficult to solve.
Thanks

Statistics: Posted by BernardAR — Fri Sep 17, 2010 9:37 am

Center Line for AX-12+

2010-09-17T00:45:17+01:00

Are you talking about lining up the line on the servo horn to the line on the servo housing? As in the picture below.

From I, Bioloid

http://mike-ibioloid.blogspot.com/

Statistics: Posted by Gort — Fri Sep 17, 2010 12:45 am

Center Line for AX-12+

2010-09-16T09:51:20+01:00

Hi, every one. I'm new in playing robots.
I need help here. Hope some one can help me.
I dismantle my spider last month and changed to puppy. After finish assemble I found out the Center Line for all the servo is not going back to the original position. My puppy is working but not in the right position. All the assemble i had check is no problem. I does not know how to adjust the servo back to the center line position.
Thanks.

Statistics: Posted by BernardAR — Thu Sep 16, 2010 9:51 am