RoboSavvy Forum

Connect RX and EX series to CM510

2010-11-07T12:45:41+01:00

Wouldn't it not be good to have some open-sourced design to get AX, RX and EX to work with CM510. Is such a pity to use CM510 for only AX.

Just a wild idea.

Statistics: Posted by Teng — Sun Nov 07, 2010 12:45 pm

Connect RX and EX series to CM510

2010-11-07T12:35:52+01:00

Which is why you need cm700. Also rx draws a lot of current not sure if cm510 can handle.

Statistics: Posted by UncleBob — Sun Nov 07, 2010 12:35 pm

Connect RX and EX series to CM510

2010-11-07T10:05:47+01:00

RX and EX use RS485 while AX uses TTL and CM510 only has TTL. Is there already or is someone thinking of coming out with something to enable RS485 and allow for more sensors to be used with CM510?

There is most likely to have lots of demand for it.

Statistics: Posted by Teng — Sun Nov 07, 2010 10:05 am