RoboSavvy Forum

ZigBee + CM5

2010-12-10T16:18:11+01:00

Using the "Behavior Control Programmer" I sent it to the CM5 program receives the data. Using the "Robot terminal" I sent it to the CM5 demo program. RX LED was on, the program was posted, but after pressing "Start" CM5 not read, even though mounted ZigBee is received.
I really can not be done using the same ladder?

Statistics: Posted by rudazolza — Fri Dec 10, 2010 4:18 pm

ZigBee + CM5

2010-12-10T14:57:00+01:00

With the standard Bioloid firmware in the CM5 no. The standard firmware uses the Zig100 to send and receive integers only and these are sent in a format which must be adhered to if you want to intrcept them with a PC.

Anything is possible if you program the CM5 directly in C.

Dewey

Statistics: Posted by Dewey — Fri Dec 10, 2010 2:57 pm

ZigBee + CM5

2010-12-09T15:32:01+01:00

Hi, I have a question, whether it is possible to download the program to CM5 using a ZigBee module? I use the "Behavior Control Programmer" and "Roboplus" for the Bioloid. I can not find info at this issue.

Statistics: Posted by rudazolza — Thu Dec 09, 2010 3:32 pm