RoboSavvy Forum

Re: Prolonged use of AX-12

2011-03-12T05:55:00+01:00

robogal wrote:
siempre.aprendiendo wrote:
Not in this case, but is has done that before, when I spent long day programming it what does the blinking mean?

Thanks it's odd that it did it in the same spot of the routine every time though!

Statistics: Posted by robogal — Sat Mar 12, 2011 5:55 am

Re: Prolonged use of AX-12

2011-03-12T05:53:33+01:00

siempre.aprendiendo wrote:
Did you see the LED of the not working servos blinking?

Not in this case, but is has done that before, when I spent long day programming it what does the blinking mean?

Statistics: Posted by robogal — Sat Mar 12, 2011 5:53 am

Prolonged use of AX-12

2011-02-28T11:51:51+01:00

The servos will automatically shut down when they heat up so you do not burn the motor.

By what you described was what happened, when you play a motion and the servo is in "safe mode" it does not move, but when it get colder starts to move again.

Statistics: Posted by nunogato — Mon Feb 28, 2011 11:51 am

Re: Prolonged use of AX-12

2011-02-27T19:00:01+01:00

robogal wrote:
I was using my Bioloid comprehensive humanoid the other day for prolonger use in a demonstration.

I found after a while the robot started making a squealing/ screeching noise. I wasn't sure if these were the servos or the plastic joints.

Also the actions of standard programs started planning up randomly. In the demo program, the dance example, the left arm wasn't lifting at the start but did later in the routine. I found if I turned it off for a while it started to work fine again. I was thinking maybe a heat issue?

Has any one else had these troubles before?

Thanks

Did you see the LED of the not working servos blinking?

Statistics: Posted by siempre.aprendiendo — Sun Feb 27, 2011 7:00 pm

Prolonged use of AX-12

2011-02-27T09:13:35+01:00

I was using my Bioloid comprehensive humanoid the other day for prolonger use in a demonstration.

I found after a while the robot started making a squealing/ screeching noise. I wasn't sure if these were the servos or the plastic joints.

Also the actions of standard programs started planning up randomly. In the demo program, the dance example, the left arm wasn't lifting at the start but did later in the routine. I found if I turned it off for a while it started to work fine again. I was thinking maybe a heat issue?

Has any one else had these troubles before?

Thanks

Statistics: Posted by robogal — Sun Feb 27, 2011 9:13 am