RoboSavvy Forum

cmucam3 with cm-5

2011-08-18T10:44:48+01:00

Changing the CM-5/CM-510 firmware. You can write a C program and connect to its serial port at 115kbps

Statistics: Posted by siempre.aprendiendo — Thu Aug 18, 2011 10:44 am

cmucam3 with cm-5

2011-08-18T02:16:18+01:00

seems like the cmu3 can only output serial or pwm. the serial is limited to 115kbps so it can not sit on the bioloid bus (like HaViMo).
AFAIK, the CM510 can't digest pwm signals. so check if you can connect the cmu3 serial to the CM510's zig100 connector or otherwise use an arduino or something small similar to link with the cmu3 over serial and output some analog signal or whatever the CM510 likes to eat.

Statistics: Posted by limor — Thu Aug 18, 2011 2:16 am

Connect CMUCam3 to Bioloid CM5

2011-08-18T00:26:13+01:00

hi,
I am with the same problem, someone can help us !?

thanks!

Statistics: Posted by tvergutz — Thu Aug 18, 2011 12:26 am

cmucam3 with cm-5

2011-07-21T18:11:21+01:00

hi all
I am from Indonesia, I want to connect cmucam3 with cm-510, if anyone can help me ??????

Statistics: Posted by nyoo — Thu Jul 21, 2011 6:11 pm