Well, after 3 days fighting with this nonsense, here I leave the scheme and the solution has lost synchronization between the Zig-110 module and its control (Zig-100) Premium Bioloid robot and GP.
If you change the ID of the command from RoboPlus Manager sicronización lose the remote control receiver with the Zig-110.
The controls Zig-100 and receiver module Zig-110, are sold together, and by default are matched with an ID for a sicronización without doing anything, without further work.
But if for some reason, you change the value of "ID" from the RoboPlus Manager, previously unlisted "ID" factory, you'll be sending to the receiver (Zig-110) wrong direction to try to synchronize with the control (Zig-100).
Fortunately, the identification of each module, they come in a few stickers inside them (Command and receiver) and can thus recover the "ID" by default and reconfigure it correctly from the RoboPlus Manager, and resynchronize the two remotes smoothly.
Both numbers are the same by adding or subtracting a number to the ID of each module.
Statistics: Posted by Kondo — Mon Jun 25, 2012 8:50 pm
]]>