RoboSavvy Forum Robosavvy Forum: The largest online community of Humanoid Robot Builders 2012-08-28T04:48:56+01:00 http://forum.robosavvy.com/feed.php?f=5&t=8189 2012-08-28T04:48:56+01:00 2012-08-28T04:48:56+01:00 http://forum.robosavvy.com/viewtopic.php?t=8189&p=35252#p35252 <![CDATA[Roboplus motion problem]]>
I have already solve the problem.

In case anyone has it you have to go to the roboplus motion.

Robot -> Edit Motion Offset.

Click Initialize and Save.

And everything is working fine.

Statistics: Posted by domatik — Tue Aug 28, 2012 4:48 am

]]> 2012-08-24T06:30:05+01:00 2012-08-24T06:30:05+01:00 http://forum.robosavvy.com/viewtopic.php?t=8189&p=35220#p35220 <![CDATA[Roboplus motion problem]]> http://support.robotis.com/en/software/ ... r_main.htm

Statistics: Posted by siempre.aprendiendo — Fri Aug 24, 2012 6:30 am

]]> 2012-08-24T02:42:10+01:00 2012-08-24T02:42:10+01:00 http://forum.robosavvy.com/viewtopic.php?t=8189&p=35215#p35215 <![CDATA[Roboplus motion problem]]>
I have a problem with my roboplus motion.

A week ago I had to restore the firmware of 3 dynamixels.

When I try to control any dynamixel with the roboplus motion all of the motors go to 0 or 1023.

The only motor that works fine is ID 1.

If I change any motor to the ID 1 it responds perfect to the roboplus motion. But when I change the ID back again It just goes to a 0 or 1023 value.

Could you help me please?!?!?

Thank you!!!

Statistics: Posted by domatik — Fri Aug 24, 2012 2:42 am

]]>