RoboSavvy Forum

Overload Condition Reset

2013-05-19T11:42:08+01:00

Friedrich, did you get it to work? I still get overload status even after doing torque on or off/on.

Statistics: Posted by ronald — Sun May 19, 2013 11:42 am

2012-11-12T12:55:34+01:00

From the AX12 manual:

To recover, the Torque Enable (Address0X18) needs to be reset to 1.

Statistics: Posted by i-Bot — Mon Nov 12, 2012 12:55 pm

2012-11-12T12:11:35+01:00

Hi,
is it possible to reset this condition via commands or is it neccessary to recycle the supply voltage?
Thx, Friedrich

Statistics: Posted by FriedV — Mon Nov 12, 2012 12:11 pm