I've an ax-12+, and when I turn it on, the led starts blinking.
I don't think it's a power supply problem, because, before it started blinking, when I turned it on by the power supply 9v(1A), led flashed once.
it started blink when I connected it by a FT232 Serial to usb converter module to PC and ran the roboplus firmware recovery, as it said when I click find, I should poweroff, power on the servo to find the servo. when I did this, it didn't find it, but the back led was turned on, after 5mins it started to blink. after that when I just power it on, it starts blink, and I wrote a code in bascom for atmega32 and connected the ax-12 data pin to Rx pin of micro for read the error, but nothing happened.
I connected AX-12 to FT232 module in this manner: I connected the ax-12 data pin to rx and tx.
Sorry if it's hard to read.
And I appreciate any helps for that.
I don't have the USB2Dynamixel and CM-5 and any other productions for AX-12, I just have The servo and want it to run without these products. but first i need to stop it from blinking.
ThanksStatistics: Posted by feri_sharp — Sat Jan 05, 2013 6:36 pm
]]>