Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

Hitec replacement servo parts

Anything that doesn't fit our other forums goes here.
3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1

Hitec replacement servo parts

Post by ostro_goto » Mon Sep 20, 2010 5:08 pm

Post by ostro_goto
Mon Sep 20, 2010 5:08 pm

Hi to all members forum, I have a question about servo HiTec HSR-8498HB. Is possible replace the Karbonite gear, with metal kit for servo HSR-5498SG?
Thanks in advance.
Hi to all members forum, I have a question about servo HiTec HSR-8498HB. Is possible replace the Karbonite gear, with metal kit for servo HSR-5498SG?
Thanks in advance.
ostro_goto
Robot Builder
Robot Builder
Posts: 24
Joined: Wed Sep 10, 2008 3:32 pm
Top

Post by PaulL » Wed Sep 22, 2010 11:43 am

Post by PaulL
Wed Sep 22, 2010 11:43 am

Hitec doesn't sell the metal gear set for the entire 5498SG servo. I tried to buy a few a while back, and found that I could only get the 1st gear (closest to motor) which is karbonite and steel (not fully steel) under a different part number, and the 2nd and 3rd gears from Hitec directly, but could not purchase the final (output) gear. Which of your gears is breaking?
Hitec doesn't sell the metal gear set for the entire 5498SG servo. I tried to buy a few a while back, and found that I could only get the 1st gear (closest to motor) which is karbonite and steel (not fully steel) under a different part number, and the 2nd and 3rd gears from Hitec directly, but could not purchase the final (output) gear. Which of your gears is breaking?
PaulL
Savvy Roboteer
Savvy Roboteer
Posts: 423
Joined: Sat Sep 15, 2007 12:52 am
Top

Post by ostro_goto » Wed Sep 22, 2010 12:06 pm

Post by ostro_goto
Wed Sep 22, 2010 12:06 pm

Hi RN1AsOf091407, the gear is last where insert round horn. I have open another post on robonova hitec. Thanks for help.
Hi RN1AsOf091407, the gear is last where insert round horn. I have open another post on robonova hitec. Thanks for help.
ostro_goto
Robot Builder
Robot Builder
Posts: 24
Joined: Wed Sep 10, 2008 3:32 pm
Top

3 posts • Page 1 of 1
Post a reply
3 posts • Page 1 of 1
Return to General