RealView ICE

[chenzhao]

For any Tech/Sales enquiry, pls drop us a e-mail: embed_support@techor.com







RealView ICE
The ARM® RealView® ICE unit is the leading-edge hardware debug solution that supports all ARM processors in single-core, multi-core, homogeneous and heterogeneous architectures, offering unparalleled support for ARM processor-based devices.

Insert image: (alt+p)
Together with the debugger in the RealView Development Suite, the RealView ICE unit enables the user to connect to, and control real silicon of ARM processor-based devices, delivering the demanding performance required by today’s developers of sophisticated system-on-chip devices and embedded system software.

New features of RealView ICE 3.3 Firmware Release:

•Full debug support for the CortexTM-A9 processor, the latest member of the Cortex family of processors; and the Cortex-R4F processor
•Support for the TI OMAP 34xx, TI OMAP 35xx, TI OMAP 1710, TI DaVinci, Freescale i.MX31 and ARM PB1176JZF-S platforms
•Introduction of streaming trace, which removes the need for expensive large buffers on trace capture units by uploading trace data to memory on the host machine, allowing for tracing over a long period of time
•Easier configuration of CoreSightTM debug and trace systems with an improved Graphical User Interface in the RVConfig utility
•An AHB Download utility enabling memory reads and writes, and code download directly via the AHB-AP bridge, giving significant speed improvements over JTAG
•USB connection to a Linux host, supporting run control, as well as streaming and non-streaming trace
•Inclusion of the CoreSight Access Tool (CSAT) enabling low-level configuration and interrogation of CoreSight systems to bring up and verify debug connectivity, read the ROM table and CoreSight registers, and download code to CoreSight devices
•Support for the CoreSight Serial Wire Output format, reducing the number of pins required for debug

Key technologies supported by RealView ICE include:

Support for the RealView Trace 2 unit
The RealView ICE unit supports the RealView Trace 2 trace capture plug-in unit, which introduces an innovative data streaming capability to the RealView tools that directly enables hardware platform profiling by the RealView Profiler product from ARM.

Debug and Trace of the Cortex Processor Family
The RealView ICE unit comprehensively supports the debug and trace technology for the Cortex family of processors to enable rapid deployment and utilization of the advanced on-chip debug and trace infrastructure. The RealView ICE unit provides the target connection and run-control capability that allows hardware and software developers to generate device bring-up and initialization code, develop firmware, boot operating systems and debug executable code.

Enhanced CoreSight Support
The RealView ICE unit extends support for the CoreSight On-chip Debug and Trace Technology to all of the available CoreSight Design Kits. System architects and software developers can now fully utilize and exploit the comprehensive debug and trace capabilities for ARM processor-based designs, to significantly improve the debug experience and speed development of higher quality products.

Serial Wire Debug Connection
The RealView ICE unit fully supports the CoreSight Serial Wire Debug technology that can be used in place of JTAG. Serial Wire Debug reduces the number of debug port pins on a device from 5 pins to 2 pins, for severely pin-limited packages and where pin count can be the controlling factor in device costs.

Third-party Debug Environment Support
The RealView ICE unit has an extensive feature set which can be leveraged within a user's preferred device connection and debug environment with the use of the Remote Device Debug Interface (RDDI). This easy-to-integrate API enables functions such as device access, register and memory interrogation, as well as reset, synchronization and start for immediate device control.


Standard features of RealView ICE include:

•Full debug support for all processors in the ARM and Cortex processor families
•High performance run control
- code download at up to 1.2Mbytes/sec
- high speed single-stepping at up to 100 steps/sec
- JTAG clock frequencies of 2KHz to 20MHz, up to 50MHz via LVDS
- wide voltage tolerance from 1.0V to 5.0V
•USB and Ethernet host connectivity
•Inclusion of RDDI-LITE utility for low-level JTAG operation programming
•GDB-Eclipse plug-in for simplified target connection and debug using the GNU debugger
•eXDI2 driver to enable debugging of Windows CE using Microsoft's Platform Builder development tools

Supported Platforms

•Windows XP Professional and Windows
•Red Hat Enterprise Linux versions 4 and 5
Latest Version
RealView ICE version 3.3 is now available directly from ARM and from your local authorised RealView Tools Distributor.

Please check RealView ICE Software Downloads for all available RealView ICE firmware releases.



•TEK-9263 ARM9 增强型开发板[ATMEL AT91SAM9263 ] - (0.00)
•ARM RealView ICE Emulator Unit 3.x(RVI)：ARM最新款RealView ICE仿真器 - (0.00)
•TEK-6400开发平台 - (0.00)
•ULINK2 ARM仿真器(ULINK2 USB-JTAG Adapter) - (880.00)
•新型高性能仿真调试Emulator工具！：TRACE-ICP,兼容TRACE32-ICD/TRACE32-ICE/TRACE32-FIRE - (0.00)
•TEK-9263 ARM9 学习板[ATMEL AT91SAM9263 升级版] - (3100.00)
•techorICE™ ARM Emulator仿真器专业版V5.2-兼容Realview Multi-ICE/RVI，支持ADS/RVDS/RealView MDK/IAR EWARM/Keil - (2800.00)
•techorICE ARM仿真器USB接口版(Multi-ICE兼容版) - (2500.00)
•techorICE™ ARM仿真器(Emulator)企业版 - (4800.00)
•T-LINK　ARM仿真器（Banyan-UE兼容)不支持PXA270版本 - (0.00)
•ARM仿真器选配件：Flash烧写软件 - (0.00)
•techorICE ARM仿真器(Emulator)USB2.0 PXA270升级版 - (3800.00)
•techorICE™ ARM仿真器(Emulator)USB2.0接口版 - (2800.00)
•移动设备开发仿真器OPENice-A1000 - (0.00)
•JUDI - (3980.00)
•JEDI-II™仿真器 - (9800.00)
•J-link兼容USB仿真器，支持IAR环境/ADS环境，支持J-FLASH烧写，无32KB代码下载限制！与全功能版本J-LINK V6版100%功能相容！ - (1200.00)
•techorICE™ Wiggler - (80.00)