by RKM83 » Wed May 14, 2008 2:38 am
by RKM83
Wed May 14, 2008 2:38 am
Hey tribleplane-
I read you tried the re-load, I had to try it a couple of times before it worked for me.
When the robot is run under very low DC voltage, sometimes, it may erase the program. Follow the user guide page 73 to 75 to load the program, motion files and default tuning setting to the controller with your PC. (Note: there is a typo error in page 74. Instead of typing 'L' to load philo program, it should be 'I'). Hope this helps.
Hey tribleplane-
I read you tried the re-load, I had to try it a couple of times before it worked for me.
When the robot is run under very low DC voltage, sometimes, it may erase the program. Follow the user guide page 73 to 75 to load the program, motion files and default tuning setting to the controller with your PC. (Note: there is a typo error in page 74. Instead of typing 'L' to load philo program, it should be 'I'). Hope this helps.