my robobuilder red led (error) keep on blingking

[chapin]

hello everyone
this is my first post i hope someone can help me
here is my problem so far my robot was working perfect but now i keep gettting the red led (error) all the time i try to charge the battery but either won't charge or i'm doing something wrong i check the charger and is fine u think the battery is no good or maybe is got to do with something else
hope someone can help me
thanks in avance

[Ketchup]

Start the "Robobuilder Diagnostic tool". Connect the Robobuilder and see what it says. I had a red flashing light and found that one of the servo leads was disconnected.

Hope this helps!

[chapin]

hello ketchup,
i try everything u say check all connections, all servos work if u use the
wck programmer but still red led blinking , i even change battery but no luck , anybody has other solution
thanks in advance

[Ketchup]

You could contact the place where you purchased it or contact Robobuilder via phone or leave a message on their forums.

I hope you get some resolution.

[l3v3rz]

Hi,

have you made any progress ?

I've seen similar problem when I had a firmware problem and it wasn't picking up the type of robot configuration. Have you checked that your serial number reads correctly and tried setting the config type by pressing PF1 at boot.

cheers