Robobuilder
Robobuilder
by nick2501
Thu Mar 17, 2011 12:23 pm
Hi, I'm new at this and thinking of using the robobuilder to identify certain routes. I would like to use an Overo™ Water COM - Gumstix and some kind of camera. If someone could advise were to start from this would help alot.
Thank you
Thank you
Camera on Gumstix
by Yamini
Fri Mar 18, 2011 6:01 am
Hi,
it depends on what you want to use the camera for.
1. If you want to use in machine vision applications then you can use the Gumstix camera launched here http://www.gumstix.com/store/catalog/pr ... cts_id=254. This can do a VGA @60fps.
2. If you need higher resolution capture like 3M pixel or above, then you can try www.e-consystems.com/omapovero.asp. This supports autofocus too. This can do a 720p@30fps.
so, based on the application you choose one of these two.
Yaks
it depends on what you want to use the camera for.
1. If you want to use in machine vision applications then you can use the Gumstix camera launched here http://www.gumstix.com/store/catalog/pr ... cts_id=254. This can do a VGA @60fps.
2. If you need higher resolution capture like 3M pixel or above, then you can try www.e-consystems.com/omapovero.asp. This supports autofocus too. This can do a 720p@30fps.
so, based on the application you choose one of these two.
Yaks
