Legacy Forum: Preserving Nearly 20 Years of Community History - A Time Capsule of Discussions, Memories, and Shared Experiences.

RoboBuilder Charging Problem

Korean company maker of Robot kits and servos designed for of articulated robots. Re-incarnation of Megarobotics.
2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1

RoboBuilder Charging Problem

Post by qsxdr » Mon Jan 02, 2012 3:40 pm

Post by qsxdr
Mon Jan 02, 2012 3:40 pm

I have a problem with my new 5720T. I can use it when it’s connected the power supply but after I disconnect, it stopped the work immediately, like there is no battery. How can I fix this problem? I bought a pre-assembled kit and used it only few days.
I have a problem with my new 5720T. I can use it when it’s connected the power supply but after I disconnect, it stopped the work immediately, like there is no battery. How can I fix this problem? I bought a pre-assembled kit and used it only few days.
qsxdr
Newbie
Newbie
Posts: 1
Joined: Mon Jan 02, 2012 3:00 pm
Top

Post by steve_jo » Mon Jan 02, 2012 4:26 pm

Post by steve_jo
Mon Jan 02, 2012 4:26 pm

You have to set it to a charging mode
With the AC adaptor connected and the control box switched on press and hold the pf1 and pf2 keys (rear right of the control box) for a few seconds.

The green power light will start flashing which means it is in charging mode.

Takes 90 mins or so and then the green led will stop flashing - the battery should be charged.

Cheers
You have to set it to a charging mode
With the AC adaptor connected and the control box switched on press and hold the pf1 and pf2 keys (rear right of the control box) for a few seconds.

The green power light will start flashing which means it is in charging mode.

Takes 90 mins or so and then the green led will stop flashing - the battery should be charged.

Cheers
steve_jo
Newbie
Newbie
Posts: 4
Joined: Thu Dec 29, 2011 6:12 pm
Top

2 posts • Page 1 of 1
Post a reply
2 posts • Page 1 of 1
Return to RoboBuilder